PROFESSIONAL TABLE MICROPHONE

Support microphone on a surface or wall.

The BM 30W is a microphone designed to be used on a surface or on a wall.
The red Led on the front grill indicates the status of the microphone.
The ON/OFF control button can be programmed using the switches at the back of the microphone.
It can work as PTT (push to talk) or PTL (push to lock) in either open or normally closed mode.
The red Led will always and only indicate the open microphone status; There is also a selector to set a pass-up filter if desired.
White cable of 3 mt from mini XLR female (on the microphone) to XLR male supplied.
Condenser cap that needs Phantom +48V power supply.
The lower part is finished with an anti-slip zigrinate elbow for an optimal grip on the support surface.

Technical specifications:

• Cardioid condenser microphone

• Complete with programmable switch/pull

• State Led

• High pass filter

• Frequency response: 30-20000 Hz

• Sensitivity: -55 dB

• Impedance: 100 ohms

• Maximum Pressure: 130 dB SPL 1 kHz at 1% THD

• Dynamics: 101 dB 

• Signal ratio - noise: 65 dB

• Power supply: 11-52 Vdc 2mA typical

• Connector: mini XLR male

• Equipped with 3 mt white cable

• Dimensions 104 mm(L) x 102 mm(W) x 21 mm(H)

• Color: White

Suitable for church altars, conference rooms, council halls, auditoriums, theatres.

Our microphones are made in Italy.

_